Power Mac G4 (QuickSilver 2002): How to Install Memory

This document discusses the steps necessary to install a DIMM into the computer.

Warning
Apple recommends that you have an Apple-certified technician install memory, PCI expansion cards, and internal storage devices. Consult the service and support information that came with your computer for instructions on how to contact an Apple Authorized Service Provider or Apple for service. If you install these items yourself, you risk damaging your equipment, and such damage is not covered by the limited warranty on your computer. See an Apple Authorized Dealer or service provider for additional information about this or any other warranty question.

See technical document 42687 "Power Mac G4 (QuickSilver 2002): How to Open the Computer" or your user's guide for steps on how to open the computer.
See technical document 42686 "Power Mac G4 (QuickSilver 2002): About Adding Memory" for memory specifications.

Important: Do not touch the DIMM's connectors. Handle the DIMM only by the edges.

Once the computer is open:

1. Open the ejectors on the DRAM DIMM slots you want to use by pushing down on them (Figure 1 - C).

2. With the ejectors in the open position (as shown), push down on the DIMM until it snaps into place. The ejectors will automatically close. Important: The DRAM DIMM is designed to fit into the slot only one way. Be sure to align the notches in the DIMM (Figure 1 - A) with the small ribs inside the slot (Figure 1 - B).

3. Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place.

4. Reconnect all cables and restart your computer.

Warning: Never turn on your computer unless all of its internal and external parts are in place and it is closed. Operating the computer when it is open or missing parts can damage your computer or cause injury.




Figure 1 (A) DIMM notches, (B) ribs in slot, (C) ejectors