Access: PublicLast modified: 2001-07-10

Power Macintosh G3 (Blue and White): Removing the Top Front Handle

This article explains how to remove the top front handle from the Power Macintosh G3 (Blue and White) computers.

Products Covered

This procedure applies to the following products:

  • Power Macintosh G3 (Blue and White)
  • Macintosh Server G3 (Blue and White)
  • Macintosh Server G3 with Mac OS X Server
Tools

This procedure requires the following tools:

  • 2.5 mm allen wrench
Part Location

 



Preliminary Steps

No preliminary steps are required before you begin this procedure.

Procedure

    1. Using a 2.5 mm allen wrench, remove the two allen screws.

    2. Lift the handle from the computer.

 


    3. Now install the replacement part. Replacement Note: When installing the handles (top front and top rear) orient them so that the three tiny bumps on the handle are in the orientation shown in the photo. The handle won't fit if it's turned upside down. The top front and top rear handles are interchangeable.


 

 

Document Information
Product Area:Computers
Category:Power Macintosh
Sub Category:General Topics
Keyword:kpmg3 kssta kss
Last Touched:2004-09-09 18:49:23
Procedure ID: 111821Writer: Ketteridge, CarolDate created: 2001-07-10